Search results

I blew the speedo side driveshaft bearing on my 02 Polaris 700. How far does the new bearing go on the shaft, flush with end of shaft? Do you just tap it on? Thanks, Tutone

I have a 2002 Polaris 700 XC SP and the resonator / silencer has an issue. There appears to be an elbow with a socket to receive the exhaust pipe at the inlet of the resonator, well the elbow broke of inside of the resonator (I shook it out) and the pipe doesnt seal now. The elbow has been...

I blew the clutch side driveshaft bearing last week so I decided to pull the skid and driveshaft out to check everthing. One of the rear skid holes (tunnel) has elongated and I can see that it will not tighten down properly. So, 2 questions. 1. What is the best way to fix the elongated hole? 2...

I have 2003 Polaris XC 340 Edge that my youngest daughter drives. It has a smaller secondary clutch (stock) on it right now. I am wondering if I could put a regular size secondary clutch on to increase speed and snap. Of course I would have to use a different belt. Really just wondering...

I have a 2000 Polaris 440 XC SP that loads up when sitting at idle or running at low speeds. What can I do to correct this? I currently have 290s in, Air Screw set to 1.25 and what I believe to be a stock Pilot. It runs great after burning out the fuel....... Thanks! Tutone

I have a 2000 XCSP 500 that is using a ton of oil. The fuel usage is slightly above normal but not like the oil!. I have heard that the oil pumps fail to full flow, is there a way to test the oil pump? Thanks!

Polaris 2000 XCSP500 Idles fine, boggy on take off, seems gurgly about until about 5-6000 rpm. The sled is also using quite a bit of oil. I have pulled the carbs and gave a quick clean. Only 1500 miles on sled. Runs great when you pin it. it does seem to pop and backfire right when coming off of...