Search results

I want to take my Dad for one last ride in the Antigo area tomorrow but I haven't been there before. Where is a convenient place to drop off at? thanks - Skutr

With John's forecast I think I can safely post my annual snow prayer>... A PRAYER FOR CHRISTIAN SNOWMOBILERS Dear God, we thank you for your goodness towards us, and for sending us your Son Jesus. Thank you for my family and friends. Thank you for my wife for allowing me to buy another sled...

I don't know if it runs. Is it worth pursuing or not? Thanks -Skutr

I'm looking for a utility sled for my Dad and I was wondering if anyone has an opinion on the 600 IQ Widetrack. FYI - my Dad's 76 yrs young and will use the sled for ice fishing, pulling a wood sled and just puttering around his land. Thanks - Skutr

The kid was buzzing around the yard with only 2 inches of snow, overheated the Indy 500 and boiled it out the overflow bottle. Thankfully he shut it down when the temp light came on so no engine damage. What's the best way to refill without getting an air pocket? Thanks - Skutr

The guy I bought my 2001 Indy 500 from several years ago gave me these brackets (see attached) and they really seem to help the handling. I have a friend that wants a set but I have never seen them before. Any idea of who made these? Thanks - Skutr

My son got his bird this morning! Thankfully it was before it started to rain. 9 inch beard!

I dropped my helmet (Pursuit M4) off the back of a pickup truck and the face shield cracked. Does anyone know if I can get replacement face shield? I would like to get a new helmet and keep this one as a backup or extra for guest riders.

Put a new belt on my sons 95 Indy Lite and it's riding a little high on the secondary and creeps forward when idling. Put the old belt on and it's fine. Thoughts? Thanks - Skutr

Ok - I've got another question for the "experts" - I've got a 1992 AC Panther 440 2-up that uses A LOT of gas. Thinking that a float was sticking I decided to clean the carbs and noticed that the float arms where sitting at different heights. One is at 14 mm and the other is at 17 mm. Which...

My 87 ski doo safari 377 bogs down when run at wide open throttle. It's ok at 1/2 or 3/4 throttle but acts like its fouling plugs at wide open throttle. If I let it sit for a while it idles and runs great until I run it wide open for about a1/2 mile and then starts to bog, cough, spit, sputter...

What's the torque specs on the lower sprocket? I know it gets loctite but is there a torque or is it just as tight as I can get it? Thanks - skutr

Here's what I found when I went to open the hood on my Arctic Cat 2-up. The nest is an exact mold of the air box and top of the engine.

My neighbor ran his sled last night with the choke 1/2 on and it only made it a few hundred yards and stopped and we couldn't get it started. The engines not seized and today it runs for a few seconds and then quits. Any ideas on what he did to it and what to do to get it running again...

I picked up a 2001 MXZ 600 and when the engine is cold it idles around 1800-2000 and runs smooth but after running around a bit it idles at around 3600-3800 and runs a little rough. Clutch engages at 4000 and the engine runs smooth with good acceleration through low-mid-high ranges and the...

I'm working on my Dads 1992 AC Pantera 440 trying to get the E-start to go and all I get is a heavy click from the solenoid. There's 12.9 volts at the battery and 12.32 volts at starter. All connections are tight and not corroded. The ground is good. I've replaced the brushes & springs and...

What would cause this type of wear on the helix & on the inside of the shaft? The two grooves that are worn into the side of the helix are not very deep but the side of the button post is getting a little thin. The only thing I can think of is that this button was wearing out faster than the...

Can I just turn the buttons around or do they only go on one way? Thanks Skutr

Which is the right thing to do? Turn the gas off or can you leave it open when on a trailer? Thanks Skutr

Anyone ever use one of these? Harbor Frieghts got them on sale for $10. Pretty quick payback, but I worry about the abraisive getting the engine. That could get expensive. Thoughts, opinions & smart answers welcome. Thanks - Sckutr