so I was out ridin this past weekend and after an hour or so of riding, I stopped to talk to my buddy and the sled died and wouldn't start back up. took the belt off to tow it back, in mid tow I tried starting it and it started but the engine light was on, today I went out and started it up and pulled the codes on it. it threw 3 codes P1102, P0545, and P0546.
I found on the internet that the P1102 code is for the throttle position sensor on the carbs, which i had uplugged before we went riding because i took the carbs off becase of water in the fuel system. so could that just not have been plugged in all the way? or had some dirt or debris in it?
and for the other two codes P0545 and P0546, i haven't had any luck finding what they are for???
any help would be greatly appreciated. Thanks
I found on the internet that the P1102 code is for the throttle position sensor on the carbs, which i had uplugged before we went riding because i took the carbs off becase of water in the fuel system. so could that just not have been plugged in all the way? or had some dirt or debris in it?
and for the other two codes P0545 and P0546, i haven't had any luck finding what they are for???
any help would be greatly appreciated. Thanks