Redneck_indy
Member
i bought a skid plate for my 2015 polaris indy. when I installed it, i made sure to follow the directions. I have it installed except for the rear two rivets in the rear of the bulkhead. The directions told me to drill two holes in the rear of the bulkhead, these to holes would be drilled right in front of the heat exchanger. the holes would be within an inch from it. Is this too close? Is there something on the other side of the heat exchanger? I don't want to accidentally drill into something on the heat exchanger. The directions say to drill there, but I don't know if I should trust it. The skid plate says it fits pro-rmk, assult, and pro R. It says nothing about being made for the indy. Dealer said it is the right skid plate becasue the indy has the pro r front end. I just don't know if maybe the heat exchanger is in a different spot on the indy. Any help would be great.