bearing behind clutch on 2002 polaris edge 600

0

02edgehead

New member
Im looking to put all new bearings while having apart to change track. sled has almost 7000 miles on. I got chaincase off and driveshaft out but cant figure out how to get the 3 nuts off that are behind frame that hold the bearing brace on. nuts are on the back side and look impossible to get at unless you take out the air/oil tank. and that is all riveted in and not easy to get at. any suggestions??
 
0

02edgehead

New member
oil tank cant stay. its all one piece. air box and oil tank is all one piece. there is two rivets across bottom and at least one buried under dash.
 
M

mikedrh

Member
Part of the wire harness runs over the top of the shaft (on most models) and makes it even harder to do.

No quick easy fix, get the harness out of the clamps, makes it a little easier to get at the nuts.

Or, drill the rivets out for the air box. You don't have to take the airbox all the way out just jack it up a little.
 
You must log in or register to reply here.
Top