Search results

the black against that green really looks nice!! track looks like new!! that's nuts!

QOC (quality of cut) variables 1. proper tire pressure 2. sharp, correct and correctly installed blades 3. proper deck level and pitch, front of deck should be 1/4 to 3 /8 inch lower than back, measured off of blade tips not deck pan, should be exactly level side to side, again measuring off...

Been with Toro for 30 years, had my own dealership for 11 years, never have I heard of mulching blades being too short, that would be new to me

yes, the deck should be lower in front than rear, I favor the high end of spec and set pitch at 3/8 of an inch, that way the leading edge of blade will be cutting the grass, and again thats measuring off of blade tips not deck pan, what's going on there has noting to do with pitch or level

IMO.... everything is better in the north woods and hope to reside in them some day, wife on same page too.

My wife and I recently spent a long weekend in St. Germain With venturenorth and his wife, we stopped at our regular favorite stops but tried a new one, Kimball Inn in by Hurley, the place is not that big and hope they keep it that way but the food they put out there is nothing short of...

Thats a cool pic!! I have that saw in my collection LOL, I believe that's a Mac I-43, its a beast just to pull, let alone use LOL!

My dad always askes me what it is I like so much about the north woods, my response is always... " the food is better and the beer is always colder in the north woods", he asks me what that means and I say "exactly what it means" LOL!!!

I will say in the past few years the show seems to be growing, the swap area this year was pretty impressive, it is also a very well attended show. Would be nice to see a little more presence from the manufacturers themselves there. Cat was there but booth really lacked luster and seemed to just...

Hopefully using a pneumatic rivet gun and not by hand, may end up with carpal tunnel from all the riveting you've done in past and doing now LOL!!

2024 Catalyst 600 137, the pristine conditions you see in picture were during the cold snap in Grand Marais last season. There were absolute perfection conditions last year, just had to drive a little to find them. Hopefully no stuck exhaust valves or broken helmet cables this year LOL, and...

250 hours is nothing on a mower, not even remotely close, I have customers with over 5000 hours on machines that are 8 years old and still going strong. Where are you located? this year has been a relentless year as far as grass growing, not to mention we are a dying breed and difficult to find...

Huge THANK YOU to the select few that make this happen!!!

30 years of doing this poop LOL!!

I'm still betting wrong blades or sprung deck, when you get it straightened out just keep in mind when leveling, do not measure off deck pan and level only applies to side to side, for a deck to cut well you need pitch and I would favor the higher end of pitch from front to back 3/8"

yes and that's the only thing I can find I think its....fake news

im thinking the guy who told me about it is confused LOL

I tried researching it, cannot find anything other than recall on a bunch of 509 helmets, we was going to get me the article so we will see.

did you measure the blades to see if they are correct? how did you measure deck level? when you rotate the blades the tip should come pretty close to the one next to it, from the looks of it I would say either blades are too short, not to ask stupid question but do you have the sail of the blade...

Does anyone have any information on a "Recall" on the Ski-doo oxygen helmet? customer of mine said they were recalling a bunch of them, was going to buy one at a dealer after I told him how much I liked mine and the dealer literally talked him out of it because of all the problems with them, he...