Arctic Cat Tech's I need some Spec's

D

doo_dr

New member
I can not find my older cat service manual. I need some altitude specs for a 2001 600 pwdr special 136 VEV/carb'ed. If my memory serves me right it gets mains and pilots and clutch weights but it has been a few years!!!

Thank you in advance!!!

Doo Dr
 
T

Team Elkhorn

Guest
Arent the specs on the decal on top of the tool holder? I have a 2000 model.
 
T

Team Elkhorn

Guest
Mines a 700 otherwise I would go out and read them to you. sorry.
 
T

Tito

New member
what altitude? Rule of thumb one jet size for 1500-1800 ft. One up on the pilot. If yours has a fuel screw might not need that. Does your PS have the compensator still on
 
D

doo_dr

New member
I'm with you but going from 900-9000K' gives you alot of varialbes. I'm looking for the factory specs. I used them on this sled a few years ago and only had to make small tweeks to have a good runner!!!

Thanks
Doo Dr
 
T

Tito

New member
  1. 9000 ft and over 19/40 gear
  2. 53 cam
  3. yellow/white drive yellow driven
  4. 0746-549 weight (46 gr)
  5. 5-9000 ft 0746-524 weight (48.5)
Get a mikuni pocket tuner wont need to rely on a jetting chart or be near the sled works for all makes
 
S

shawnl

New member
-40 to -20
430 440

-20 to 0
410 420

0 to +20
390 400

+20 to +40
380 390
All altitude
needle jetQ-3(480)
jet needle 6EGJ1-3
pilot jet 40
This is for a 1998 powder special if this helps
 
You must log in or register to reply here.
Top