Changing oil in Crossfire ACT drive?

C

cf700

New member
I have a 2006 Crossfire 700 that needs the oil in the drive changed. I have been told it is better to remove the drive and split the case to clean and inspect the bearings and gears. Where can I find information on the procedure to remove and reinstall the drive? Any information would be appreciated! Thanks!!!
 
E

ezra

Well-known member
did one tonight.I did my sled a few weeks back pulled dd out yes you have to pull long bolt out of break side and unplug speed sensor wire plug hiding above wire behind alloy and pry out rubber boot between dd and bulkhead bolt hiding behind.OK that was the first today I just pulled cover took a bit of light prying and pulling because gasket is permatex.there are Sm slots in dd to put screwdriver in to pry open. you have to cut the zip tie holding speed sensor wire.only 3 oz so I just put paper towel in pan to catch oil could have used drain plug but did not.cleaned with break cleaner both halves.cleaned off old permatex.tipped sled on side with handlebar on 5gal bucket thin coat of permatex to both halves of dd and dumped in the sm can of oil and put dd back together.had to jimmy track back and fourth a in or so then top of dd dropped on.bolted together new zip tie tipped back down bolt clutch back on all about 35 or 40Min
 
E

ezra

Well-known member
btw doing it the way I just posted you can not pull lower gear buy you can still get cleaner in behind
 
C

cf700

New member
Thanks for the info.That is exactly what I needed, now I just have get my *** out to the garage and do it!
 
You must log in or register to reply here.
Top