FLY F2 Helemt

S

se3racing

New member
Just picked up a FLY F2 Carbon Helmets. Not sure how to put the cold plugs in if I need to. Do you take the liner out to install plugs? Also is the liner a snap in or Velcro in. Don't want to screw it up trying to figure it out. There was no instructions about the liner or the cold plug kit.
 
S

ski_dog

New member
Great helmets, I have 2 of them. The cheek pads are on snaps. You'll need to take these out to put the breath guard in as it hooks through the straps. I took the neoprene piece off the breath guard as this will create a better seal for your goggles. As far as the plug kit, you won't need to remove the liner (which just pushes in with tabs, no Velcro or snaps). You can push the liner to the side to access the holes that you'll be plugging at the top of the helmet. Any other questions let me know. Good luck!!
 
You must log in or register to reply here.
Top