Polaris 2013 800 Switchback PRO-R

wolfboy

New member
I am having issues with my sled.
1. Have to give it gas to start.
2. Has power at lower speeds but bogs when you get on the throttle.
3. Check engine light has come on a few times then it goes into limp mode. This only happens momentarily then returns to normal.
4. No top end power or speed.
5. Seems to be using more gas then friends with exact same sled.

I changed the plugs and ran some seafoam but the problem is getting worse.

If anyone has any ideas feedback would be greatly appreciated.

Thank you!
 
D

Deleted member 10829

Guest
Could it be the Throttle Position Sensor? Just a guess. Good luck with it!
 

ezra

Well-known member
I was thinking reeds my self but they usually burble at the low end also with busted reeds. prob with the new computer controlled high pressure fuel sleds is it can be almost anything . check your fuel line in tank. bud just went through it on his 13 rmk dry rotted lines but his would just not run after about 5000rpm and run bad up to that .don't the poo have a port dealer can plug in to
 

raceinsnow

New member
As polarisrider said check compression, I would say reeds or piston problem. Dont run it any more untill you find out what is going on because it will cost alot more to fix if it takes out a cylinder or case.
 
Top