track removal on m8

[k_smith]

Hi I was wondering if any one could tell me how to get the drivers out so i can switch tracks on my m8. i have been told that you do not have to take the gearcase apaart or anything like that. sled is a 2008 if that matters at all. any help is greatly appreciated. thanks again kyle smith

 

[cuzzinolaf]

Hi I was wondering if any one could tell me how to get the drivers out so i can switch tracks on my m8. i have been told that you do not have to take the gearcase apaart or anything like that. sled is a 2008 if that matters at all. any help is greatly appreciated. thanks again kyle smith

1. Drop the Skid
2. Pull the drive shaft bolt (need a really long extension)
3. Take the Diamond Drive out (7 bolts I believe)
4. Take the brake caliper out
5. Pull the drivers

Simple. Obviously more involved but that is the gist of it. I think you'll have to remove the reverse servo too but can't remember.

 

[stealthv]

I've found it easier to finagle the DD case out with the reverse servo assembly removed - It's only two torx screws and one electrical connection.

 

[ezra]

go to www.hardcoresledder.com and go to 136 xfire section under cat and picks are at the top of the thread 2 guys under 1.5 hr to swap track with dd I have done it in under 1hr buy my self but have done it a few times