snocatmike
New member
I am with ubee had my 99 600 do this track froze to ground and then someone gave it the gas and burned belt in that spot.
99 xc sp 700-lots of vibration in the footwells
- Thread starter indy_500
- Start date
indy_500
Well-known member
these sleds r very coldblooded and like to burn the belt when cold i will make sure to check that (again i'm not in a hurry on this sled and i have a longer explanation to why i just don't go out and check the belt lol) but it shall happen tomorrow!
my 750 storm had the same jackshaft bearing at the clutch.
let_it_snow
New member
Drive shaft bearing
Buddy had a vibration like this. It was the drive bearing/ where the speedo cable goes in. The speedo still worked the bearing was still in one piece but was trashed. Felt very rough when it was spun once we took it out. Put in a new bearing and greased it up. No more vibration.
Buddy had a vibration like this. It was the drive bearing/ where the speedo cable goes in. The speedo still worked the bearing was still in one piece but was trashed. Felt very rough when it was spun once we took it out. Put in a new bearing and greased it up. No more vibration.
indy_500
Well-known member
my dad and his buddy both think that. i'm sure it's a bearing or a track issue. not too worried.