Current one is all aluminum and super light for an 4 place unit, other than wind issues, half ton truck would be happy towing it; I run diesel 3/4 or 1 ton and they do not know it's back there. The higher trailer clearance with a deckover makes it nicer negotiating snow piles at gas stations/parking lots.
My suggestion would be to get a trailer that is tall enough to easily stand up in, so you don't knock your head very often, especially when you still have your helmet on. If you are deciding between inline and parallel, ask yourself if all of the sleds are coming out everytime as in how much will you be handling a given machine if it's not going to be ridden on that trip. Also get a trailer that is longer than you need to account for the next sled that will be longer than what you have now.
All good info! I believe my 27'(22' box + 5'V), weighs right around 3K. My diesel pulls it very well. We'll sometimes take my dad's Suburban.
Crazy weight difference compared to my old steel deckover.
I feel the 22' box is a good fit. I've been able to get 5 sleds in mine before.
To answer your question plus some others I've received about the trailer and things I have thought about I've tried to lay out some points below. So first I have a 2014 - 7.5'x27' R&R 7522PSD The trailer tows great even in deep snow. I never had any problems with that.
Suspension - Hands down upgrade to the torsion axles this will help the ride and when towing.
If I were to do it again what would I do differently?
I only wired mine for 120V/30AMP service. Wire it for 120V/50AMP you can always use less power. As long as you use RV plugs there are many adaptors to step down usage when not pulling large loads. My point is if you think you only need 15AMP get 30AMP, If 30 will work get 50AMP. If the manufacturer will not install a larger service. (some will not) Specific the main wire size to them. Where you want the power coming in the trailer and where you want a load panel, that you can install later. Give yourself lots of outlets inside. I would also do lights on both the AC and DC sides. 30APM is most likely more than enough unless you plan on running multiple electric heaters.
Lights outside - I ran LED strip lights down both sides of my trailer. I have backup lights as well. All the outside lights flood the area around the trailer very well. The only spot I forgot was the nose of the trailer. Right where you are messing with everything hooking up. (Maybe this summer...)
Floor - Lots of options here too, and something I still trying to figure out. I talk to a few guys that have used race deck flooring. Mine was painted before I got it. It looks good for a few years but then it needs to be redone... I would not paint it. One of my friends did spray in bed liner. It can be a bit slick... but durable...
Oh, different levels of trailers will use different floor decking. Some are just treated decking others are waterproof engineered decking boards. Carbides still dig in but not as bad as the cheaper options. I have the caliber guides down the center of my trailer now. Then move the sleds to stager them...
Nice setup!
I agree with the torsion axles. I ordered 5200 torsions on mine. I went with the larger weight since I was customizing it.
I went with 30A service on mine. I doubt I'll ever use it over 15A/20A, but it's there if needed.
I have factory installed rear backup lights, plus an additional LED backup.
I put one over my front ramp also. You can never have enough light!
The race deck is very nice. I'm planning on installing that in the next year or too. I use a combination of ski runners/track guides, and conveyor belt. I had all that from my last trailer, so the cost was already taken care of.
What do you use for heat? Propane? I didn't see the tanks?
I have a 35K BTU propane heater and a 15 gallon propane tank installed underneath. I just got back from a 4 day trip from the UP. I kept all my gear and sleds in the trailer, set to a comfortable 63F the entire weekend. My dual golf cart batteries will only last about a day, otherwise I need a generator or plugged in. I do have solar, but it usually not enough to keep up with the demand, especially on the cloudy days.
I do have a floor drain installed for all the melting of the sleds. That thing is always full in the morning. Pull the plug and drain it.
I fully insulated mine from top to bottom.