L 
		
				
			
		lenny
Guest
This will be my 8th year of plowing snow and I am still getting my truck stuck somewhat often. I plow a few different properties and the flat ones I only get stuck when I over drive the truck onto a snow bank,,my mistake. I am getting better at not doing this but sometimes I push it a little to hard and get the plow hung up and have to shovel it loose. The problem I am referring to is when I am plowing down hill driveway and need to push snow off the side of the driveway, back up onto plowed area and continue down the hill to push more snow off the side and when I back up on a steeper slope I get stuck some what easily. My truck does not have a limited slip differential on either the front or rear so when the tire that looses traction, this same tire just receives more torque thus sending little to no torque to the other side and than I am stuck,,,remember I am on a hill backing up. No doubt skill is a factor  but equipment comes in real important on some situations such as the one I am talking about. Tonight I was stuck and I was not hung up on snow anywhere, clean in front of all tires just a little ice under and I have 1 tire in front and 1 tire in the rear spinning. My little dinky Rhino pulled it out without a tug, just tightened up the strap and pull it out. In fact this stuck was only a slight downhill, I was ticked off. 
I want a electric actuated locker. This will provide equal traction to both shafts (wheels) only when I flip the switch and when not flipped it will act as an open rear end. In most situations I will not need this but it is hilly in my area and I need more traction and fear a limited slip will not be enough. I have asked a few guys in my area and none have lockers but most have newer trucks than me and have limited slip. At the same time none have such a hilly drive as mine.
What do you guys think?
My truck is a 85 Dodge W250 with very good bitting tires, runs great, just need more traction.
	
		
			
		
		
	
			
			I want a electric actuated locker. This will provide equal traction to both shafts (wheels) only when I flip the switch and when not flipped it will act as an open rear end. In most situations I will not need this but it is hilly in my area and I need more traction and fear a limited slip will not be enough. I have asked a few guys in my area and none have lockers but most have newer trucks than me and have limited slip. At the same time none have such a hilly drive as mine.
What do you guys think?
My truck is a 85 Dodge W250 with very good bitting tires, runs great, just need more traction.