Sk-doo XP 8" Riser

[06mxzx]

I have a 2010 Ski-doo backcountry x with a 4 inch stock riser on it. Thinking about buying an 8" riser...will I need cable extensions?

 

[paul_z]

no

 

[t660redrocket]

NO!!!

 

[michaeladams]

bring a ladder

 

[indy_500]

doubling it will make it very tall.

 

[06mxzx]

Go big or go home!


TEAM RIDEHARD!

 

[sledjunkie25]

I'm in the same boat...only i have an '04 renegade so do i need cables then?

 

[indy_500]

if you re-route, you should be fine. here's my re-routing job

notice the brake line that i made a short cut for on the left side

 

[indy_500]

srry, wrong file. don't have it on the hard drive so i can' upload it. but anyways, i have a 99 indy 500 and cut out some of the plastic covering up the handlebar heater wires and made a shortcut for my brake cable

 

[doospunk]

06MXZ - Your fine. I swapped my stock 8 inch on the 09 Summit to a 10" with no problem. I don't see why you'd have less slack.

sledjunkie - I've got an 04 renegade also. Went from stock to 6" Pivot PowerMadd setup. Had to buy the Summit break cable, but was able to keep/route the stock throttle cable.

 

[06mxzx]

Thanks for the input guys can't wait to hit the POW POW!!

TRH

 

[06mxzx]

Just put on the riser and the brake cable is a little tight and I am not seeing an alternative route to give me extra slack...Any input guys?

 

[t660redrocket]

clip the cable ties holding the brake cable. There are usually 3 of them. That will give you all you need right there. Instead of leaving all your cables flop you can re-tie the rest of them.

 

[06mxzx]

Just went out and looked. Only saw one tie zip tie...cut it and gave me no more slack...am i missing something?

 

[06mxzx]

Got it all figured out...thanks guys